I have a report where the detail records can number over 100 records at times. When the report is generated the first page of the detail records has a large margin at the bottom so about 40 records gets printed on the first page which includes the headings. When the detail records roll over to the 2nd or 3rd page the detail starts at the VERY top edge of the paper, and the laser printer does not print that part of the page. (see the attached.
Is there any way to control these margins on the page so that if the detail records run over onto a 2nd or 3rd page they do not start printing at the very top edge of those pages?
Any suggestions would be greatly helpful on how to control the margins for the pages on reports.
Welcome to the nuBuilder Forums!
Register and log in to access exclusive forums and content available only to registered users.
Register and log in to access exclusive forums and content available only to registered users.
Report Detail Page Margins
Report Detail Page Margins
You do not have the required permissions to view the files attached to this post.