nuBuilder Forum

Hi-

Hope someone can help. I've searched around and couldn't find anything.

I'm trying to set up a basic Lookup Object. So far, when you go to the edit screen (of an existing record), it displays the current info correctly, and auto-complete works correctly.

But, when you click the magnifying glass, open the Lookup Form, and select a row there, it doesn't enter the info back in the edit form. In fact, I believe it blanks out any previous info, if you were trying to change the entry.

I've compared my set up to the sample, and I can't see anything different, and the sample works correctly.

Does anyone know what might be causing this?

Thanks so much!!!!

(By the way, thought I'd mention the thread about Lookup key field needing to be different from Lookup code field was very helpful.)

Nevermind. Figured it out.

My fix to the problem I mentioned at the bottom meant adding a new Primary Key to the Lookup Table, and I didn't change that in the Lookup Table Form Primary Key Field.

Thanks anyway.

Nice software!!

Nice work Eggsalad!